![background image](http://html.mh-extra.com/html/wen/tt1015/tt1015_instruction-manual_956583027.webp)
27
ADJUSTMENTS
MITER GAUGE SLOT AND BLADE ALIGNMENT
For the best results, the miter slot should be adjusted parallel to the
blade. This is done at the factory, but if it is not exactly parallel, fol-
low the steps below to reduce the risk of kickback.
WARNING!
Disconnect the machine from the power source
before performing the following steps.
1. Remove the blade guard (See "INSTALLING THE BLADE GUARD"
on page 15).
2. Raise saw blade to its maximum height.
3. Set the bevel to 0° angle.
4. Use an adjustable square (not included) to measure the distance
from the miter slot to a carbide tip on the blade (Fig. 37). Make sure
that the face of the adjustable square is even along the miter slot.
5. With the end of the adjustable square just touching the tip, lock
the square in place. Mark the carbide tip with a marker (not included)
where you made this measurement.
6. Rotate the marked blade tip to the other end of the table insert.
7. Slide the adjustable square down to the other end of the table in-
sert, and compare the distance from the marked blade tip to the end
of the adjustable square.
• If the blade tip measurement is the same on both sides, the miter
slot is parallel with the table; the procedure is complete.
• If the blade tip measurement is not the same on both sides, the
table will need to be adjusted. Proceed to step 8.
8. To adjust the table, slightly loosen the cap screws in the trunnion
mounting locations (Fig. 38) and slightly tap the trunnions in the
needed direction. Repeat steps 2 through 5 until the blade and miter
slot are parallel.
9. Tighten the trunnion mounting cap screws.
Fig. 37
Fig. 38
Upside down
view of the
Table Saw
Summary of Contents for TT1015
Page 38: ...38 NOTES ...
Page 39: ...39 NOTES ...