![background image](http://html.mh-extra.com/html/wen/tt1015/tt1015_instruction-manual_956583013.webp)
13
INSTALLING THE FENCE
NOTE:
The fence is shipped in its storage position on the
left side of the saw.
1. Loosen the lock knob (Fig. 2 - 1), then remove the fence
assembly (Fig. 2 - 2).
2. Install the fence locking knob (Fig. 3 - 1) (found in the
hardware bag) on the front rail.
3. Place the fence on the rails, with the mounting holes po-
sitioned over the (3) pre-installed mounting screws. Then
tighten the fence locking knob (Fig. 4 - 1) to secure the
fence.
NOTE:
The fence can be installed in 1 of 2 positions. The
inner position (closer to the blade) can be used for rip cuts
up to 24" wide. The outer position can be used for rip cuts
up to 28" wide.
ASSEMBLY
WARNING!
Do not plug in or turn on the tool until it is fully assembled according to the instructions. Read
through and become familiarized with the following procedures of handling and adjusting your tool. Failure to
follow the safety instructions may result in serious personal injury.
Fig. 2
Fig. 3
1
1
Fig. 4
2
1
Summary of Contents for TT1015
Page 38: ...38 NOTES ...
Page 39: ...39 NOTES ...