![background image](http://html.mh-extra.com/html/wen/tt1015/tt1015_instruction-manual_956583020.webp)
CROSSCUTTING
Crosscutting is to cut a workpiece across its main grain or
its width. Follow the steps below to make a cross cut.
OPERATION
Fig. 27
WARNING!
Serious injury can be caused by kickback. Kickback can occur when tension is created between
a workpiece sitting against the fence and the blade. This can cause the workpiece to be thrown toward the
operator or bystanders. To prevent kickback, review the "SPECIFIC RULES FOR YOUR TABLE SAW" section.
WARNING!
Disconnect the machine from the power
source before performing the following steps.
1. Remove the fence assembly.
2. Set the blade height 1/8” higher than the top of the work-
piece.
3. Set miter gauge to 0° and place it in the desired slot.
4. Hold the workpiece firmly against the miter gauge with
the blade path aligned with the desired cutting location.
Leave the workpiece at least an inch away from the blade.
5. Connect the machine to power and start the machine,
and allow the blade to come up to full speed.
WARNING!
Keep both hands away from the blade
and the path of the blade.
6. Keep the workpiece firmly against the face of the miter
gauge while holding the workpiece flat against the table.
7. Slowly push the workpiece through the blade until the
workpiece is pushed completely past the blade.
WARNING!
Never pull the workpiece while the
blade is turning.
8. Turn off the table saw, allow the blade to come to a com-
plete stop, and carefully remove the workpiece.
20
Summary of Contents for TT1015
Page 38: ...38 NOTES ...
Page 39: ...39 NOTES ...