![background image](http://html.mh-extra.com/html/wen/tt1015/tt1015_instruction-manual_956583021.webp)
21
OPERATION
Fig. 28
WARNING!
Disconnect the machine from the power
source before performing the following steps.
BEVEL CROSSCUTTING
Bevel Crosscutting is to cut a workpiece across its main
grain or its width with an angle other than 0°. The operation
is the same as crosscutting except with an angle. A bevel
crosscut is shown in Fig. 28.
WARNING!
Keep both hands away from the blade
and the path of the blade.
1. Remove the fence assembly.
2. Set blade height 1/8” higher than the top of the workpiece.
3. Set miter gauge to 0° and slide its rail to the desired slot.
4. Tilt the blade to desired angle (see page 17, "BEVELING THE BLADE").
5. Hold the workpiece firmly against the miter gauge with the blade path aligned with the desired cutting location.
Leave the workpiece at least an inch away from the blade.
6. Slowly push the workpiece through the blade until the workpiece is pushed completely pass the blade.
7. Turn off the table saw, allow the blade to come to a complete stop, and carefully remove the workpiece.
RIPPING
Ripping is to cut a workpiece along its main grain or its length. Follow the steps below to make a rip cut.
CAUTION!
Workpiece must have a straight edge placed against the fence.
DO NOT
make rip cuts in warped,
twisted, or bowed workpieces.
1. Measure the workpiece. If the width of the workpiece is between 2 and 6 inches, use the included push stick to
feed the workpiece. If the width of the workpiece is less than 2 inches, use the auxiliary fence.
NOTE:
When ripping longer workpieces, use the rear extension for extra support.
2. Remove the miter gauge. Set the fence to the desired cut width and lock the fence in place.
3. Set blade height 1/8” higher than the top of the workpiece.
4. Hold the workpiece firmly against the fence with the blade path in line the desired cutting location. Leave the
workpiece at least an inch away from the blade.
5. Have the push stick ready.
6. Plug the saw in and start the saw.
7. Use the push stick to slowly push the workpiece through the blade until the workpiece is completely past the
blade.
8. Turn off the table saw, allow the blade to come to a complete stop, and carefully remove the workpiece.
Summary of Contents for TT1015
Page 38: ...38 NOTES ...
Page 39: ...39 NOTES ...