Welbilt Convotherm mini black easyTouch 10.10, Installation Manual

Page: 34 / 148

No. Safety device Function Check
3
Unit door cracked-open
position
Prevents steam coming out
from scalding the operator's
face and hands
With the combi oven at a low
temperature, check the door
positions as described in
'Safely Opening and Closing
the Unit Door' in the operating
manual
4
Suction panel inside
the oven cavity; can on‐
ly be removed with
tools
Prevents staff from reaching
into the moving fan and en‐
sures proper heat distribution
Please refer to
'Removing and Installing the
Suction Panel' in the operat‐
ing manual
5
(not
shown)
Automatic safety rins‐
ing after power outage
if there was cleaning
agent inside the combi
oven when the power
went out
Starts the fully automatic
cleaning sequence (Convo‐
Clean system) again, from a
defined state, after a power
outage
The software will monitor this
6
(not
shown)
Spray stop
■
Stops cleaning agent spray‐
ing in the fully automatic
cleaning sequence (Convo‐
Clean system) when the unit
door is opened.
■
Prompts the user to close
the unit door
The software will monitor this
7 (installed
by the
customer)
Disconnector
■
Installed close to the unit by
the customer. Easily visible
and accessible, all-pole, with
a contact gap of at least
0.12"
■
Used to de-energize the unit
during cleaning, repairs, and
maintenance work, as well
as in hazardous situations
Procedure:
■
Trip the disconnector
■
Check that all three phases
are de-energized at the
unit's -X10 terminal block
8
(not
shown)
Only for setups involv‐
ing a base with casters:
Retaining element
Limits how much the entire set‐
up (base and unit) can move
from its location
Check to make sure that the
retaining element is properly
attached
3 For Your Safety
Installation Manual 34