Innovation - Edge [i] Installation, Operation, Maintenance Manual
CHAPTER 7
– TROUBLESHOOTING GUIDE
OMM-0143_A
• GF
-216
•
9/6/2019
Technical Support
•
(800) 526-0288
•
Mon-Fri, 8 am - 5 pm EST Page 97 of 170
CHAPTER 7.
TROUBLESHOOTING GUIDE
7.1 INTRODUCTION
This troubleshooting guide is intended to aid service/maintenance personnel in isolating the
cause of a fault in an Innovation Water Heater. The troubleshooting procedures contained
herein are presented in tabular form on the following pages. These tables are comprised of
three columns labeled: Fault Indication, Probable Cause and Corrective Action. The numbered
items in the Probable Cause and Corrective Action columns correspond to each other. For
example, Probable Cause No. 1 corresponds to Corrective Action No. 1, etc.
When a fault occurs in the unit, proceed as follows to isolate and correct the fault:
General Troubleshooting Instructions
1.
Observe the fault messages displayed in the Edge Controller display.
2.
Refer to the Fault Indication column in Troubleshooting Table 7-1 which follows and locate
the Fault that best describes the existing conditions.
3.
Proceed to the Probable Cause column and start with the first item (1) listed for the Fault
Indication.
4.
Perform the checks and procedures listed in the Corrective Action column for the first
Probable Cause candidate.
5.
Continue checking each additional Probable Cause for the existing fault until the fault is
corrected.
6.
Section 7.2 and Table 7-2 contain additional troubleshooting information which may apply
when no fault message is displayed.
If the fault cannot be corrected using the information provided in the Troubleshooting Tables,
contact your local AERCO Representative.
NOTE
:
The front panel of the
Edge
Controller contains an RS232 port. This port is used only by
factory-trained personnel to monitor OnAER communications via a portable computer.