![background image](http://html1.mh-extra.com/html/watts/aerco-inn-1060n/aerco-inn-1060n_installation-operation-and-maintenance-manual_877211083.webp)
Innovation - Edge [i] Installation, Operation, Maintenance Manual
CHAPTER 6
– MAINTENANCE
OMM-0143_A
• GF
-216
•
9/6/2019
Technical Support
•
(800) 526-0288
•
Mon-Fri, 8 am - 5 pm EST Page 83 of 170
Fireside Inspection Instructions
PARTIAL RIGHT-SIDE VIEW
– BASE & SUPPORT BRACKET REMOVED FOR CLARITY
Figure 6.7-1: Intake Manifold & Exhaust Manifold Locations
CAUTION!
The intake manifold, burner and exhaust manifold assemblies weigh approximately 25 pounds.
Use care when removing these assemblies in the following steps.
11.
While supporting the intake manifold, loosen and remove the six (6) 5/16-18 hex nuts
securing it to the studs protruding from the exhaust manifold.
12.
Carefully lower and remove the intake manifold, burner assembly, two burner gaskets (P/N
GP-18899
), and the intake manifold flange gasket (P/N
81198
). See Figures 6-3 and 6-4.
13.
Disconnect the exhaust temperature sensor (Figure 6.7-3) by unscrewing it from the exhaust
manifold.
14.
While supporting the exhaust manifold, remove the two (2) side nuts (Figure 6.7-3) securing
the manifold to the heat exchanger. Loosen, but
do not remove
the third nut nearest to the
front of the unit.
15.
Remove the exhaust manifold from the unit.
16.
Inspect the exhaust manifold and burner assemblies for debris. Clean out debris as
necessary.
17.
This completes the fireside inspection of the unit. Proceed to step 18 to reassemble the unit.
EXHAUST
MANIFOLD
HEAT
EXCHANGER
INTAKE
MANIFOLD
5/16-18 HEX
NUTS (6)
CAP SCREWS (4)
1/4-
20 X 7/8” (22.2 mm) Long
1/4-20 SCREWS
(2)
DO NOT REMOVE