WattMaster Auto-Zone Plus, Design, Installation And Operation

Page: 73 / 180

Auto-Zone Plus Section 3
Programming 3-5
View Alarms Screen
Alarm Address Locations
Alarm Clearing
SYSTEM ALARM STATUS
Alarm @ Unit ID 118
The System Manager can be programmed to poll all the Auto-
Zone units on your system for alarm information. This allows
the centrally located System Manager to display an Alarm
Indicator whenever an alarm condition exists anywhere on
your system. The actual alarms are not displayed on this
screen, only the Unit ID where the alarm is located. The
example shows that a unit at location 118 has experienced an
alarm condition. This alarm may or may not be current, as the
System Manager latches the alarm condition. This makes it
possible to determine if any intermittent alarm conditions have
occured. If you have Level 2 access, you can enter the full
system access mode, select that unit for display, and determine
what the exact alarm condition is for that unit. The alarm
conditions are always displayed on the Status Screens.
SYSTEM ALARM STATUS
Clear Alarms? YES
To Change Response
Use Left/Right Arrow
If all the alarm conditions have been corrected at the individual
units, you can clear these alarms from the System Manager on
the following screen. Use the Left/Right arrow keys to select
the YES/NO response desired. If you clear the alarms, but
some still exist, the System Manager will show an alarm
indication, when the affected unit is polled again.
firealarmresources.com