Solvent bottle tray
Detector
Column heater
Sample manager
Solvent manager
Sample organizer
Waste container
Leak path
Required waste lines
A.6 Connecting to a wall electricity source
Warning:
To avoid electric shock, observe these precautions:
• Use SVT-type power cords in the United States and HAR-type power cords, or
better, in Europe. For requirements elsewhere, contact your local Waters distributor.
• Inspect the power cords for damage and replace them if necessary.
• Power-off and unplug each module before performing any maintenance operation
on it.
• Connect each module to a common ground.
Note:
Some column modules, such as the column heater (CH-A), the column heater 30 cm
(CH-30A), and the column manager auxiliary (CM-Aux), receive their power from the sample
manager via the interconnect cable.
Recommendation:
Use a line conditioner and uninterruptible power supply (UPS) for
optimum, long-term, input-voltage stability. Contact Waters to ensure the correct selection and
size.
To connect to a wall electricity source:
1.
Connect the female end of the power cord to the receptacle on the rear panel of the
module.
2.
Connect the male end of the power cord to a suitable grounded wall outlet.
April 4, 2018, 715005704 Rev. A
Page 60
