A.7 Connecting signal cables
The rear panel of the module includes a removable connector that holds the screw terminals for
the I/O signal cables. The connector is keyed so that it can be inserted only one way.
Required tools and materials
• 9/32-inch nut driver
• Flat-blade screwdriver
• Connector
• Signal cable
To connect the cables:
1.
Insert the connector into the connector port on the module's rear panel.
Figure A–4: Inserting connector into connector port
Connector port
Connector
2.
Using the flat-blade screwdriver, attach the positive and negative leads of the signal cable
to the connector.
Tip:
Refer to the cable-connection label affixed to the rear panel of the module.
April 4, 2018, 715005704 Rev. A
Page 61
