Before Installation
VERY IMPORTANT!
Carefully read through this instruction manual and check that
all environmental requirements can be met to prevent voiding the warranty.
The installation sequence must be followed in the correct order and as specified
in this user manual. The unit and CO
2
bottle must be installed upright as shown in
the diagrams in this manual. In the event of a leak or electrical fault, the unit must
be isolated from both power and water supplies and advice should be sought
from a qualified technician.
Note:
To comply with Australian Plumbing Standards, the supplied pressure
limiting valve must be installed. This will prevent damage or malfunction in case
•
Caution: The STM1 system is designed for mains/town water supply only and
this supply must be microbiologically safe and disinfected if appropriate.
• Check the appliance rating
(see specifications for power requirements), and
ensure the correct power supply is available for the appliance and that the
relevant circuit will not be overloaded.
• Check
that the unit and tap locations are within reach of each other and within
reach of the power and water connections.
•
There must be sufficient room for the appliance inclusive of ventilation
requirements for other appliances within the cupboard and in general. Ensure
that the cupboard is capable of supporting the appliance. Provide for 24 kg, which
includes a gas bottle.
Note:
If required, provide additional ventilation within the cupboard before
starting the installation. The aim is to avoid cupboard temperatures reaching 40°C
or above. Inadequate ventilation can lead to malfunction and may as a
consequence void the warranty.
Installation Note:
Although failure can happen early due to unforeseen
circumstances, a water filter system like any product, has a limited life and may
eventually fail. To avoid possible property damage, this product should be
regularly examined for leakage and/or deterioration and replaced or serviced
the line pressure exceeds 350 kPa, which is the recommended limit for the STM1 unit.
Copyright Sodatap© 2023 Page 9 STM1 Manual V10
