Procedure for CO
2
cylinder installation
The following instructions refer to
Figure 16:
1.
Position the CO
2
bottle upright and as close to the unit as possible.
Note:
Any CO
2
bottle should always be upright during transit, storage and use.
If the bottle has been left horizontal, place it upright and let it stand for at
least 60 minutes to allow the contents to settle before installing.
2.
3.
Connect the CO
2
bottle to the pressure regulator by firmly screwing the
regulator
counter-clockwise
onto the bottle. Avoid overtightening as this may
damage the sealing rubber and cause a leak. Apply some soapy water on the
connection between the bottle and pressure regulator to test for leaks.
Note
: When the valve in the bottle is depressed during connection, some CO
2
Figure 16:
CO
2
Cylinder Installation
Ensure the red regulator valve is in the off position by turning it to
perpendicular with the gas line.
may escape. (sodastream type bottle only)
Copyright Sodatap© 2023 Page 24 STM1 Manual V10
Please wear protective gloves and screw
the bottle on as fast as possible.
