Plumbing Installation
–
ST1 Tap
The following instructions refer to the diagrams in Figure 7:
and Figure 8:
Complete STM1 Installation (ST1 tap and parts as listed)
1.
A 26 mm hole is required for the ST1 tap (max. 30 mm). Select a suitable
position for the tap on the counter top so that it will dispense into the sink
bowl with ample clearance below the outlet.
2.
Isolate the existing water supply. Uninstall the connections on the existing cold
water line and connect the 3-way valve. Reinstall the previous connection to
the 3-way valve.
3.
Connect the inlet of the pressure limiting valve to the outlet of the 3-way valve
using a suitable length of the supplied tubing. Observe the water flow
direction as illustrated in Figure 8:
Complete STM1 Installation (ST1 tap and
4.
Connect the straight connector to the tube on the tap.
5.
Connect the wiring loom to the tap after removing the black plastic nut from
the tap thread. Be sure not to bend or break the pins.
6.
Carefully feed the wiring loom, straight adaptor and tap connections through
the tap hole and place the tap in position, ensuring it sits flush with the
counter top.
7.
Screw on the tap nut and tighten, making sure the tap is correctly positioned
on the counter top. Installing the tap on a sink instead of a counter top may
require more care to align all the parts. HAND TIGHTEN ONLY - overtightening
may split the plastic nut.
Copyright Sodatap© 2023 Page 12 STM1 Manual V10
