Leakage Detection
When a leak detector is present and it detects a leak, the LED light in the tap will
flash. Proceed as follows:
1.
Isolate the water supply at the 3-way valve (lever in perpendicular position).
2.
Unplug the unit from the power supply.
3.
Remove the side panel of the unit, wipe off any excess water from the probe
of the leak detector and the base panel.
4.
Replace the side panel.
5.
If leaking continues, please contact the distributor or a qualified technician.
Figure 19:
Leak Detection
Copyright Sodatap© 2023 Page 30 STM1 Manual V10
