8.
During and after plumbing installation, ensure that all switches at the rear
panel of the unit remain off.
9.
Choose the best position for the unit with the required 150 mm clearance for
ventilation at the rear and at the top of the unit. Allow access room for
changing filters at the top of the unit and a suitable place where water spillage
will not cause damage to property.
Note:
If the cupboard does not permit enough space for filter changes, leave
enough tube length to allow the filter system to be removed from the
cupboard to change the filters.
10.
With a suitable length of tubing, connect the outlet of the pressure limiting
valve to the water inlet at the back of the unit.
11.
With a suitable length of tubing, connect the straight adaptor to the water
outlet, trimming back any excess tubing.
12.
Attach the wiring loom from the tap to the unit, taking care not to bend or
break the pins.
13.
Connect the power cord at the rear of the unit to the power outlet.
Note:
DO NOT turn on the water or power supply, this will be done in the
Cold/Ambient Water Commissioning steps.
Copyright Sodatap© 2023 Page 14 STM1 Manual V10
