WL500
Manual
Page 10 Revision 4‐10‐2019
OPERATING INSTRUCTIONS
The above picture shows front LCD display and control Panel for the
Waterlogic WL500
Water
Treatment System
.
Buttons
Instructions
1
Press Cold Selection (Button 1), followed by the Main Dispense
button
2
Press Sparkling Selection (Button 2), followed by the Main
Dispense button
3
Press Hot Selection (Button 3), followed by the Main Dispense
button
4
Press Extra Hot Selection (Button 4),
Wait approximately 30 Seconds.
Press Hot Selection (Button 3)
* This procedure will raise the hot water temperature
approximately 2
o
F. Repeating the process over again will raise
the temperature about 2
o
F more until the desired temperature is
reached up to a maximum limit of 203
o
F.
NOTE:
Default selection mode is Cold Water. Selection will return to default after 3 seconds of
inactivity. The default selection can be programmed to Cold or Sparkling. See Programming section of
this manual.
Main Dispense Button