![background image](http://html2.mh-extra.com/html/waterlogic/wl500-sparkling/wl500-sparkling_manual_3667426076.webp)
WL500
Manual
Page 76 Revision 4‐10‐2019
ELECTRICAL SUPPLY TROUBLESHOOTING ‐ QUICK GUIDE
1.
Circuit Breaker Tripping
2.
Circuit Overload
3.
Short Circuit
4.
Ground Fault
5.
Ground Fault Circuit Interrupter (GFCI) Tripping
SAFETY PRECAUTIONS
Basic safety precautions should be followed, including the following:
DANGER!
If incorrectly installed, operated or maintained, this product can cause death or severe
injury.
Those who install, operate, or maintain this product should be trained in its proper use,
warned of its dangers, and familiar with the tools and equipment before attempting to install,
operate, or maintain the product.
DANGER!
ELECTRICAL SHOCK HAZARD
.
Always unplug or isolate from power supply prior to servicing
equipment to prevent electrical shock. Only authorized technicians familiar with electrical safety
should attempt this advanced troubleshooting.
Contact Waterlogic if you need any assistance or help finding an authorized service representative.
Power Supply Requirements and General Guidelines
Ensure Power Supply is 120V 60Hz AC with a minimum of 15‐amp service.
No other equipment is to be connected to the outlet.
Use only Waterlogic Supplied Power Cord.
Never Use Extension Cords.
Typical Duplex Outlet is wired to carry 15 amps. Waterlogic units will draw approximately 6‐7 amps at
full load. However, the current can spike up when the Compressor first starts and the heater is on.
Always use a minimum 15‐amp service to supply a Waterlogic unit.