![background image](http://html2.mh-extra.com/html/waterlogic/wl500-sparkling/wl500-sparkling_manual_3667426072.webp)
WL500
Manual
Page 72 Revision 4‐10‐2019
1.
Ensure plastic sleeve is in place and properly seated. There
should be approximately ¼” of probe sticking out the end.
2.
Ensure O‐ring is in place.
3.
Tip should be clean and in good condition and the Level Probe is
installed
DANGER!
If incorrectly installed, operated, or maintained, this
product can cause death or sever injury.
All individuals who
install, operate or maintain the WL500 Water Treatment System
should be trained in its proper use, warned of its dangers, and
should read the entire product manual before attempting to
install, operate or maintain.
WARNING!
HIGH PRESSURE C0
2.
Disconnect WL500 Water
Treatment System from power. Shut off C0
2
to isolate Sparkling
Chamber and relieve pressure in Tank through the Pressure Relief
Valve before removing the Probe for inspection.
CAUTION!
RIBBON CONNECTORS MUST BE FULLY ENGAGED.
Ensure Ribbon Connectors are properly engaged and fully seated
in Front PCB (Printed Circuit Board) to avoid intermittent /
connectivity issues any time the Front Hatch Panel is accessed.
Filters Counter is enabled
and there is no signal.
Disable the Filters Timer.
6.
Display indicates “UV Fault” – Audible Alarm will sound for 15 Seconds
Possible Reason
Solution
UV Lamp Failed
Verify the UV Sensor is properly
installed into Cold Tank UV Lamp
Retaining Nut to ensure proper
orientation.
Always ensure the UV light is properly
installed into cold tank cap to ensure
proper operation.