WÄRTSILÄ Vasa R22, Instruction Manual

Page: 137 / 297

6 Re-install the shaft piece
(3), clean the threads of the fas-
tening screws (10) thoroughly and apply Loctite 242 to them.
7 Put the axial washer (13) to end of the shaft
8 Tighten the screws (10) to the stated torque and put the
locking wire (14) to the screws.
9 Re-install the cover (11) and tighten the screws (12).
10 Lift up the balancing shaft (9) (by the crane) and move it
back to direction of the flywheel.
11 Put the bearings (4) to the shaft, at the same time as you
let it down.Install the bearing bracket.
12 Clean the threads of the fastening screws (7)
thoroughly and apply Loctite 242 to them.
13 Tighten the screws
(7) to the stated torque value. Lock
with the wire.
14 Clean the threads of the fastening screws (6)
thoroughly and apply Loctite 242 to them.
15 Tighten the screws (6) to the stated torque.
11.3.3 Removal of balancing shaft gear
1 Turn the engine into a position where the balancing shaft
eccentrics point downwards.
2 Follow the steps in section 11.3.1.
3 Loosen the screws (6) and remove the shaft pieces (3).
11.3.4 Installing balancing shaft gear
1 Push the driving gears of the balancing shafts so that
they mesh when the guiding pins are horizontal in relation to
the centre line of the engine, Fig 11-4.
22-9601 Crank Mechanism 11
VASA 22 11 - 11