Walther prazision 91489, Working Instruction

Page: 24 / 191

Working instruction
english
typ 91489
Description of installation
24
Caution!
Please observe position of the earth contact!
13. Linearly slide in contact sockets/ contact pins with a WALTHER assembly tool
(inserting tool) until they snap in – row for row.
14. Check the perfect snap in by a slight pulling at the single conductors.
15. Disassemble the contact sockets/ contact pins by means of a suitable
disassembly tool – squeeze out from plug side.
16. Linearly insert ready made socket/pin insert into socket/pin insert holder
17. Secure socket/pin insert with circlip for shafts (circlip pliers).
18. Insert socket/pin insert holder with circlip for shafts according to pin coding.
In doing so please note that cable is pushed back so far through
the screwed cable gland that a sufficient overlength remains in the plug housing.
19. Fasten socket insert holder with4 countersunk head screws M5 with
a hexagon screw driver SW3.
20. Tighten screwed cable gland so that sealing and internal cable tension relief
becomes effective.
21. Sideways sliding in of the electro plugs into the guide of the tool changer plate
until it matches with the pin bores.
22. Beat in and counterbore parallel pins from inside through plate and electro plug.
Connection of 2 plug with 1 hybrid cable inserts
See above process
To lead the cable from one plug nest to the other the blanking plug item 16 and/or 34 can
be taken off. With a suitable tool a cable can be guided while being put through the bore.
Then mount the blanking plug item 16/34 again.