Walther prazision 91489, Working Instruction

Page: 23 / 191

Working instruction
english
typ 91489
Description of installation
23
Signal plug with Aluminium housing (screwed cable gland Pg 21)
Fehler! Textmarke nicht de-
finiert.
Shielded version
Fehler! Textmarke nicht definiert.
1-95285-1-XX001-....-Z10
1-95285-4-XX001-....-Z10
(Cable-Ø 11,5 ... 15,5)
Unshielded version
1-95285-1-XX001-....-Z11
1-95285-4-XX001-....-Z11
(Cable-Ø 13 ... 18)
Installation sequence
1. Disassembly of parallel pins item 28/67 by means of a hammer or mandrel Ø 7. Pins with
female thread can be removed with a suitable pull off device.
2. Push electro pin sideways out of the guide.
3. Release the 4 countersunk head screws M5 with a hexagon screw driver SW 3.
4. Fitting position of the socket and pin insert to the housing part is determined by a pin coding.
5. Pull socket/plug insert holder out of the electro plug housing part.
6. Take off circlip for shafts in socket and/or pin insert holder with assembly tool.
7. Linearly pull out socket/plug insert (insulating body).
8. Lead electro cable through screwed cable gland.
9. Dismantle line and strip the insulation of the single conductors, both according to dimension.
In case of shielded version connect shield by interrupting the cable sheath in the area of the
ring spring of the screwed cable gland (see appendix II) or internal twisting in plug housing
and clamping with threaded pin.
10. Crimp (4 point crimping) single conductor to contact socket/contact pin.
Strands must be visible in window after crimping.
11. Absolutely avoid solder beads at the outside of the contacts when soldering.
12. Pre-plug contact sockets into the rear of the socket insert ( contact pins in pin insert),
row for row. Blind bores must be sealed with blanking plugs.