WAGO-I/O-SYSTEM 750
Commissioning 153
750-8207 PFC200 CS 2ETH RS 3G
Manual
Draft version 1.2.1 from 2017-09-13, valid from FW Version 02.06.20(09)
7.8.1.34.3 “Add New v3 User” Group
You can enter 10 users.
Table 100: WBM “Configuration of SNMP v3 Users” Page – “Add New v3 User” Group
Parameters
Explanation
Security Authentication
Name
Enter the user name here. This name must be
unique; a pre-existing user name is not accepted
when entered here. The security authentication
name can have a maximum 32 characters, without
any spaces.
Authentication Type
Specify the authentication type for the SNMP v3
packets.
Possible values:
- Use no authentication (“None”)
- Message Digest 5 (“MD5”)
- Secure Hash Algorithm (“SHA”)
Authentication Key (min.
eight char.)
Specify the authentication key here. This
authentication key must have between eight and 32
characters, without any spaces.
Privacy
Specify the encryption algorithm for the SNMP
message here.
Possible values:
- No encryption (“None”)
- Data Encryption Standard (“DES”)
- Advanced Encryption Standard (“AES”)
Privacy Key (min. eight
char.)
Enter the key for encryption of the SNMP message
here. If nothing is specified here, the “authentication
key” is automatically used. The privacy key must
have between eight and 32 characters, without any
spaces.
Notification Receiver IP
Specify an IP address for a trap receiver for v3 traps
here. If no v3 traps are to be sent for this user, this
field remains blank.
Click
[Add]
to add a new user. The changes only take effect after restarting the
controller. For this purpose, use the WBM reboot function. Do not shut down the
controller too early!
