Burner Setup
HI 110 / 200 / 300
42
ghi_tx001449gb.fm
6.3
Setting Up the Burner
Factory
settings
Background
The burner consists of several different components and subsystems. Each of these
components or subsystems must be operating correctly for the burner to function properly.
Tools required
The following tools are required to adjust the burner:
High-quality combustion analyzer
Smoke spot tester
Fuel pressure test gauge
General hand tools
Mandates
Adjustments made shall be done so that the machine conforms to the require-
ments of local, state, and federal codes and authorities.
Adjustments shall be made at the job site.
When
Adjust the burner:
Before operating the machine at elevations 305 m (1,000 ft) above or below the
location of where the last adjustments were made
Before starting at a new job site
After any burner maintenance or repair has been performed
If burner performance is in question
Procedure
Follow the procedure below to set up the burner.
1. Shut down the machine.
2. Set the burner electrodes.
(See topic
Checking and Adjusting the Oil Burner Electrodes
.)
3. Check the burner nozzle.
(See topic
Checking/Changing the Burner Nozzle
.)
4. Set the air band.
(See topic
Setting the Air Band
.)
5. Start the machine and the burner.
6. Check/set the fuel pressure.
(See topic
Adjusting the Fuel Pressure
.)
Machine
Nozzle size
Fuel pressure
Air band setting
gph
psi
bar
Diesel
Winter blend
HI 110 D
0.55 x 80W
217
15
3.0
2.0
HI 110 HD D
0.55 x 80W
217
15
3.0
2.0
HI 200 D
1.10 x 80W
181
12.5
3.8
3.0
HI 200 HD D
1.10 x 80W
181
12.5
3.3
2.6
HI 300D
1.50 x 80W
200
13.8
6.8
3.4
HI 300HD D
1.50 x 80W
200
13.8
3.5
3.2
