W6 N 5000 Exklusive, Manual

Page: 111 / 169

Sewing buttonholes
Using a pattern
2. Place the button in the holder. If the button does not fit in the holder, adjust
the buttonhole foot’s attachment to the diameter of the button plus the
thickness of the button.
b: Button thickness
3. Thread the upper thread through the opening in the buttonhole foot and
leave the upper thread on the left-hand side.
4. Place the fabric under the presser foot so that the centre line mark is in the
centre of the buttonhole foot. Lower the foot.
c: Slide the presser foot attachment back,
so there is no gap between the attachment and the presser foot.
5. Lower the buttonhole lever as far as possible.
NOTE: If you do not lower the buttonhole lever properly, the indicator light will
light up red and the sewing process will stop after 2 to 3 stitches. The buttonhole
lever is located on the left-hand side, behind the needle threader.
111