56
2.
Thoroughly clean the cylinder liner collar. Fit a
new O-ring on the cylinder liner.
Note: The O-ring must be dry.
3.
Apply an even, max. 0.8 mm, thick bead of seal-
ant round the liner shelf.
Within 20 minutes from the time this is done, the
cylinder liner must be fitted in the cylinder block.
4.
Fit the cylinder liner according to the line-up
marking on the cylinder block.
5.
Carefully tap the cylinder liner down into the cyl-
inder block using drift 6599 and handle 2000.
Apply load to the the cylinder liner with two tools
2666.
The load must not be taken off the cylinder liner until
the cylinder head is fitted in position.
6.
Place tools 6664 on top of the cylinder liner. Oil
the piston. Fit piston and connecting rod in the cyl-
inder liner with the “FRONT” markings pointing
ahead.
7.
Check to make sure the connecting-rod bearings
are fitted correctly in the connecting rods and cap.
Oil the connecting-rod bearing journals and shells
with engine oil. Fit the caps according to the line-
up marking.
2666
2000
2666
6599
