71
3.
Fit a new sealing ring.
Fit the shaft and the rear discs.
5.
Fit the bolts and washers as shown in the figure.
6.
To torque tighten the bolts properly, a tool like the
one shown here should be made by the workshop.
40 mm
Ring grip
15 mm
Decapitated
sleeve (socket)
4.
Fit the front discs.
7.
Tightening torques:
Nm
kpm
Clamp bolt ......................... 114
±
10
11.4
±
1.0
Flange bolt ......................... 62
±
5
6.2
±
0.5
NOTE! Torque will be 4% greater if above work-
shop-made tool is used.
Tightening torque
with special tool:
Nm
kpm
Clamp bolt ......................... 110
11.0
Flange bolt ......................... 59.7
6.0
8.
Check basic timing, see page 97.
