29
Removing and installing rear
engine
Special tool:
(998) 5654 Engine carrier trolley
Drain the coolant and engine oil (see pages 25 and 26).
The engine is suitably lifted out together with the gear-
box. To remove and install, run the engine carrier trol-
ley in underneath the engine and adjust the supports,
see next page.
Always turn off the power with the battery main
switch.
To observe when removing/installing the engine
Fuel system
Open the fuel pipe joint at the gearbox.
Bolting
Engine mounts
80 Nm (8 kpm)
Propeller shaft
54 Nm (5.4 kpm)
Inlet and exhaust systems
Disconnect the inlet hose from the turbocompressor.
Disconnect the exhaust at the flex hose between the tur-
bocompressor (exhaust brake/EPG) and the silencer
hook.
Remove the intercooler pipes under the engine
to make room for the engine carrier trolley.
Disconnect the coolant pipe hose. Otherwise,
the coolant pipes can remain in place.
Observe due care with regard to the fuel
system delivery pipes! After the engine
has been disconnected from its mounts,
pipes, electric cables, etc., draw the
engine-gearbox out sideways so that the
delivery pipes are free from the frame
member.
The steering servo pump is detached from
the engine and hung up in a suitable place.
Detach the bracket from the frame
member. Detach the engine rear mount
pad.
Release the bracket from both the
frame member and the engine mount
pads.
