CONDEXA PRO
20
DISPLAY MODE
The red LED (see ref. 4 on page 18) comes on in the event of faults that cause the permanent lockout of a heating unit
(normal operation is reset only by pressing the Master or Slave reset button).
The 3 digits with seven segments display the status of the system:
Status of the system
Display
No central heating or DHW demand.
The two digits on the right display the outlet temperature T1. E.g.: T1 = 30°C
Demand from circuit no.1 or from circuits 1 and 2 together.
The two digits on the right display the outlet temp. T1. E.g.: T1 = 80°C
Demand from the DHW circuit or simultaneous operation.
The two digits on the right display the outlet temp. T1 E.g.: T1 = 80°C.
The decimal point after the 1st digit on the left flashes
Demand from the 2nd circuit
The two digits on the right display the outlet temperature T1. E.g. T1 = 80°C.
READOUT MODE
(TEMPERATURE VALUES AND OPERATING STATUS OF THE VARIOUS CIRCUITS)
Press the "SEL" button to scroll forwards and display the values set for the individual circuits.
The values listed below will be displayed in sequence when pressing the "SEL" button.
Value displayed
Display
1
Outlet temperature T1 in the high temperature circuit. E.g. : T1 = 80°C
2
DHW temperature T3. E.g.: storage heater temperature = 50°C
3
Outside temperature T4. E.g. T4 = 7°C
4
Outlet temperature in 2nd circuit or low temperature circuit T6
5
Room thermostat in the 1st circuit, closed or open.
OFF = contact open
ON = contact closed
6
Room thermostat in the 2nd circuit, closed or open
OFF = contact open
ON = contact closed
7
0-10V analogue input
E.g. 5.5V, 10V
Summary of Contents for CONDEXA PRO 100 S
Page 72: ...CONDEXA PRO 72...
Page 73: ...CONDEXA PRO 73...
Page 74: ...CONDEXA PRO 74...
Page 75: ...CONDEXA PRO 75...