CONDEXA PRO
43
In TEST mode, a high temperature heating demand at
maximum output can be generated.
To do this:
- Press the “
MODE
” and “
+
” buttons together for 5
seconds;
- Start the boiler by adjusting the room thermostat.
The boiler will operate at maximum output showing "H"
on the display, followed by the outlet temperature
(chimney sweep function);
- Check that with the burner on at maximum output the
gas pressure is the rated supply pressure, as shown in
the table to the side;
- Adjust the thermostat so as to stop the boiler;
- Press “
MEMO
” to exit TEST mode;
- Disconnect the pressure gauge and tighten the screw
on the pressure test point (3) upstream of the gas
valve.
CHECKING COMBUSTION
- Power-up the boiler by moving the main system switch
and the main switch/switches on the appliance to "on";
In TEST mode, a high temperature heating demand at
maximum output can be generated.
To do this:
- Press the “
MODE
” and “
+
” buttons together for 5
seconds;
- Start the boiler by adjusting the room thermostat.
The boiler will operate at maximum output showing "H"
on the display, followed by the outlet temperature
(chimney sweep function).
ON
OFF
3
DESCRIPTION
G20
G30 G31
Wobbe index
45,7
80,6
70,7
MJ/m
3
Rated supply pressure
20
28-30
37
mbar
Summary of Contents for CONDEXA PRO 100 S
Page 72: ...CONDEXA PRO 72...
Page 73: ...CONDEXA PRO 73...
Page 74: ...CONDEXA PRO 74...
Page 75: ...CONDEXA PRO 75...