41
Decoder Options
D4200
D
ECODER
S
YSTEM
T
AB
Reboot
– This button reboots the unit.
Factory Default
– This button factory defaults the unit. See section
CEC-Power-On
– Used to tun a device on using CEC control commands. See section
CEC Over IP (Decoder Only).
CEC-Power-Off –
Used to tun a device off using CEC control commands. See section
CEC Over IP (Decoder Only).
CEC-GENERIC
– Used to change a device input/source (HDMI -1, HDMI-2, HDMI-3, TOGGLE MUTE) using CEC control commands. See
section
CEC Over IP (Decoder Only).
Change Password
– This button changes the unit’s web interface login password to values entered below (default is admin).
• Password – enter new password
• Reenter Password – reenter new password
Important
: Make sure you write the new password down. If it is lost or forgotten, you will need to call Visionary Solutions
support to assist in a console factory default of the unit.
Set update file
– Browse to a new firmware file supplied by Visionary Solutions or downloaded from
Update Unit
– This button will initiate a firmware update per the specified file above.
Information
– Real-time status messages displayed during a reboot, firmware update, or factory default action.
