Vision Engraving & Routing Systems 1624R, User Manual

Page: 96 / 131

Vision Series 5 Controller User Manual 96
© 2019 Vision Engraving Systems
Using the goto first position feature is typically used to manually set the Z surface location at the start of
the engraving location. The surface location can be set with the surface sensor or manually set. Both
ways are described below.
Automatic surface setting:
The sense surface button is used to automatically set the material surface.
1. Insert the surface senor plug into the carriage assembly plug as shown below.
2. Attach the surface block clip to the spindle as shown below.
3. Place the surface block on the material as shown below.
4. Use the jog buttons on the Set XYZ screen to move the tool over the location where the surface will
be set.
5. Press the Sense button on the Sense Material section on the Set XYZ screen. Once the cutter
touches the surface block as shown below, the spindle will stop moving down and the surface will be
set.