Vision Engraving & Routing Systems 1624R, User Manual

Page: 19 / 131

1624R, 2525 and 2550 Series 5 Installation 19
© 2019 Vision Engraving Systems
13. Spindle Cable. Connects to the machine's controller and provides power to the engraving or
router motor.
14. Auxiliary Power Cable. This cable is pre-wired on all 16 and 25 Series Router models. It
connects an alternate power supply to the High Frequency Router Motor or Porter Cable Router
Motor. If your machine is equipped with only the Engraving Head, this cable will not be used and
can remain disconnected.
15. DACS Ethernet Plug. Pre-wired on all 16 and 25 Series Routers, this plug connects to an
Ethernet extension cable which is plugged into the network hub/host computer. It allows
communication between the DACS Camera and the DACS Software.
16. X-Axis Leadscrew. The X-axis leadscrew is located on the rear of the gantry. The X-axis
leadscrew drives the carriage assembly in the X-axis along the gantry.
17. X-Axis Linear Rails. Mounted on the rear of the gantry are stainless steel rails with sealed
bearings, which control the motion of the carriage along the X-axis.
18. DACS Ethernet Port. Located on the rear of the carriage assembly. The supplied 3' Ethernet
cable plugs into this port and also into the DACS Camera.
19. Spindle Port. Located on the rear of the carriage assembly, the motor plug from the router or
engraving motor connects to this port and provides power to the router or engraving motor.
20. Proximity Sensor Port. Located on the rear of the carriage assembly, the secondary proximity
sensor connection is only used with the optional High Speed Engraving Spindle. It allows the
proximity sensor on this spindle to connect to the machine's controller through the table cable.
21. Surface Sensing Block Port. Located on the rear of the carriage assembly, this port is used to
connect the optional Surface Sensing Block to the machine in order to quickly set the material's
surface position.
22. Oscillating Knife Port. Located on the rear of the carriage assembly, this port is used to connect
the optional Oscillating Knife to the machine.
23. Misting System Port. Located on the rear of the carriage assembly, this port is used to connect
the power cable to the optional UNIST Misting System.
24. DACS Power Port. Located on the rear of the carriage assembly, this port is used to connect to
the power cable supplying the optional Ethernet DACS Camera.
25. Misting System Power Plug. This plug is used to connect the table to the machine's controller
and provides power to the optional UNIST Misting System.