Vision Engraving & Routing Systems 1624R, User Manual

Page: 108 / 131

Vision Series 5 Controller User Manual 108
© 2019 Vision Engraving Systems
Pressing either the XY speed, Z speed or spindle speed will display a numeric keypad.
Enter the desired speed increase or decrease percentage and press enter.
The default value of 100 is the speed that was sent over in the job file from the material settings in the
Vision software.
This can be changed to values between 10% to 200%. 10% will adjust the speed down to 10% of the
original speeds. 200% will double the speed.
Increasing or decreasing this value will not go above or below the minimum and maximum speeds
available for the machine.
When either the XY speed or Z speed overrides are entered, it will take several moves before the speed
change is applied.
When the spindle speed override is applied, the speed change is applied immediately.
The reset overrides button change the XY speed, Z speed and spindle speed back to 100.
When the reset overrides button is selected, the XY speed or Z speed will take several moves before the
speed change is reset. The spindle speed will reset immediately.
Selecting the run button will exit the adjust screen and return to the run screen.