22
Setting Up the Printer
Load Label Media
Make sure the unwinder is properly aligned with the printer before you load media.
Refer to the alignment instructions for the VIPColor unwinder model (
Type 1
or
Type 2
) that you are using.
Type 1
Type 2
Printer
Unwinder
Rear rubber feet of printer fit into
the holes marked “U” on the base
of the unwinder.
Make sure the printer sits firmly
on the base.
Inner disk
Left edge
Inner disk on unwinder aligned
with left edge of media feed slot.
(a)
(b)
25 mm
(a)
Distance of 25 mm (0.1”) between left edge
of unwinder and rear left edge of printer.
(b)
(0.1”)
