22
Initial start−up, inspection and maintenance
Further details regarding the individual steps
(cont.)
Burner installation
1.
Insert the burner and secure nuts
(6×M6) by hand.
Then tighten
diagonally
to 3Nm.
2.
Secure the gas connection pipe
with a new gasket.
¨
Safety instructions
Carry out a leak test.
3.
Push plugs
fA
and
lÖ
onto the
burner control unit.
Checking all gas equipment for leaks at operating pressure
¨
Safety instructions
Carry out a leak test.
1.
Insert new gaskets in all fittings
that have been opened.
2.
Open the gas shut−off valve.
3.
Check all joints for leaks.
4.
Start up the burner.
Checking the mixer
(if installed)
for ease of operation and leaks
1.
Remove the motorised lever from
the mixer handle.
2.
Check the mixer for ease of
operation.
3.
Check the mixer for leaks.
Replace the Orings if the mixer
leaks.
4.
Snap the motorised lever into
place again.
5692500GB
Summary of Contents for CU3
