Vidipac VSW7242, User Manual, Page: 54 / 288

54
State
This column shows the current state of the port as seen from the Limit Control's point of view. The state
takes one of four values:
Disabled: Limit Control is either globally disabled or disabled on the port.
Ready: The limit is not yet reached. This can be shown for all actions.
Limit Reached: Indicates that the limit is reached on this port. This state can only be shown if Action is
set to None or Trap .
Shutdown : Indicates that the port is shut down by the Limit Control module. This state can only be shown
if Action is set to Shutdown or Trap & Shutdown .
Re-open Button
If a port is shutdown by this module, you may reopen it by clicking this button, which will only be enabled if
this is the case. For other methods, refer to
Shutdown in the Action section.
Note that clicking the reopen button causes the page to be refreshed, so non-committed changes will be
lost.
Buttons
Refresh: Click to refresh the page. Note that non-committed changes will be lost.
Save: Click to save changes.
Reset: Click to undo any changes made locally and revert to previously saved values.
4.4.2.2 Security / Network / Network Access Server Configuration
This page allows you to configure the IEEE802.1X and MAC-based authentication system and port
settings.