Videotec NXPTZ, Instruction Manual

Page: 75 / 414

Instruc
tion manual - English - EN
73 MNVCNXPTZT_1710_EN
PROBLEM Error E1-AUTOPAN WITHOUT
LIMITS.
CAUSE The two presets used as limits have
not been programmed.
SOLUTION Program the two presets and then
update the Autopan configuration
menu (11.2 Saving a Preset, page 64 e
9.1.6.7 Autopan Menu, page 42).
PROBLEM Error E2-WIPER BLOCKED.
CAUSE The wiper is either jammed or broken.
SOLUTION Check that the wiper is free to move.
PROBLEM Error E3-PATROL WITHOUT PRESET
or error E4-PATROL, 1 PRESET ONLY.
CAUSE The presets have not been
programmed.
SOLUTION Program two or more presets and
then update the Patrol configuration
menu (11.2 Saving a Preset, page 64 e
9.1.6.6 Patrol Menu, page 42).
PROBLEM Error E5-IR TEMP. TOO HIGH or error
E6-IR FAULT.
CAUSE The infrared illuminator is not working
properly.
SOLUTION Contact the authorized service centre.
PROBLEM Error E7-PRST. NOT CONFIGURED.
CAUSE Recalling of a non programmed
preset.
SOLUTION Save the preset using the relative
control (11.2 Saving a Preset, page 64).
PROBLEM Error E8-TOUR NOT CONFIGURED.
CAUSE Recalling of a non configured Tour.
SOLUTION Save the Tour using the relative
control (11.6 Recalling a pattern
(Tour), page 65).
PROBLEM Error E9-TEMP. TOO LOW.
CAUSE The environment temperature is too
low.
SOLUTION The movements of the P&T unit
is blocked to prevent mechanical
damage.