Videotec NXPTZ, Instruction Manual

Page: 62 / 414

EN - English - I
nstruc
tion manual
60 MNVCNXPTZT_1710_EN
9.3.7.1 Autopan Page
From menu entry Autopan it is possible to specify the
preset autopan start and end.
It is possible to set the speed with which the distance
is to be covered.
Fig. 114
9.3.7.2 Patrol Page
From menu entry Patrol it is possible to specify the
preset patrol start and end. It is possible to specify
whether the scan of the presets needs to be carried
out randomly or otherwise.
Fig. 115
9.3.7.3 Motions Recall Page
From menu entry Motion Recall it is possible to
specify a time interval of inactivity after which Pan
& Tilt will carry out one of the following functions:
return to Home position, start autopan or start patrol.
Fig. 116
9.3.8 Preset Parameters page
From menu entry Preset Parameters a number of
parameters relative to the presets can be configured:
•
Scan Speed:
The speed, measured in degrees to
the second, at which a preset is reached by explicit
operator request.
• Ramp type: This allows you to select the Pan & Tilt
accelerations.
• Speed Of Movements (Default): The speed used
in autopan and patrol operations.
• Impose default speed: The default speed will also
be set as the scanning speed for all presets.
• Default Dwell Time: The amount of time, in
seconds, it stays in each preset by default.
• Impose default pause: The default pause will be
set for all presets.
Fig. 117
9.3.9 Preset Parameters page
(Advanced)
In the Preset Parameters (Advanced) section it is
possible to customise the speed and pause values
for each preset, in addition to enabling/disabling the
presets themselves.
Fig. 118