Videotec NXPTZ, Instruction Manual

Page: 67 / 414

Instruc
tion manual - English - EN
65 MNVCNXPTZT_1710_EN
11.3 Restore a Preset position
(Scan)
Using the control device it is possible to recall a
previously saved Preset position (for additional
information refer to the manual of the device being
used).
11.4 Patrol enabling
To activate/deactivate this function, refer to the
manual of the control device used or to the relative
chapter (11.13 Special controls, page 67).
To deactivate this function, move the joystick or
restore a different type of movement.
Refer to the relative chapter for the configuration of
this function (9.1.6.6 Patrol Menu, page 42).
11.5 Autopan enabling
The Autopan function loads the 2 saved Presets in a
continuous manner.
To activate/deactivate this function, refer to the
manual of the control device used or to the relative
chapter (11.13 Special controls, page 67).
To deactivate this function, move the joystick or
restore a different type of movement.
Refer to the relative chapter for the configuration of
this function (9.1.6.7 Autopan Menu, page 42).
11.6 Recalling a pattern (Tour)
The Tour functioning mode allows the repetition of a
previously recorded route in a continuous manner.
The pan & tilt can store up to 3 Tours, each lasting no
more than 2 minutes.
To save a Tour, enter the special preset of the number
of Tour to be saved using the keyboard (11.13 Special
controls, page 67).
To simplify the recording of the Tour, the pan &
tilt automatically limits the speed of the Pan & Tilt
depending on the Zoom factor.
While the Tour is being recorded, the remaining
recording time is displayed, as shown in the figure.
ID: 1
------------------------
RECORDING TOUR MODE
Iris to stop 99%
------------------------
Pan : - 5.56
Tilt: +120.01
Zoom: 36.00x
Fig. 128
To interrupt recording, press the Iris Open or Iris Close
key.
To start the play-back of a Tour, enter the special
preset of the number of Tour to be displayed using
the keyboard (11.13 Special controls, page 67).