Videotec NXPTZ, Instruction Manual

Page: 20 / 414

EN - English - I
nstruc
tion manual
18 MNVCNXPTZT_1710_EN
7.1.5 Connection of the Ethernet cable
The operations described in this chapter
can only be performed in the versions with
a product network card.
Do not connect RS-485 cable and the video
cable when using an IP camera.
The multicore cable has 2 Ethernet B-type numbered
cables inside. Cable number 1 corresponds to the
IP output of the standard camera. Cable number 2
corresponds to the IP output of the thermal camera.
(if present).
Perform the connections following the instructions
reported in the table .
CONNECTION OF THE ETHERNET CABLE
Pin number Cable color
1 Orange-White
2 Orange
3 Green-White
4 Blue
5 Blue-White
6 Green
7 Brown-White
8 Brown
Tab. 2 Both cables must be crimped in the same way.
The example below shows a typical installation.
Switch
Personal
Computer
Fig. 12
7.1.6 Telemetry lines connections
CDS installation type (Cable Distribution
System). The installation is type TNV-1, do
not connect it to SELV circuits.
The cables allow access to 2 RS-485 serial
communication lines.
The lines can be configured in various ways according
to the dip-switch settings of the configuration board (
Fig. 16, page 20).
Telemetry lines connect the device to control and
programming units (keyboard or PC).
TELEMETRY LINES CONNECTIONS
Cable color Description
Yellow RS-485-1 line, A (+)
Red RS-485-1 line, B (-)
Blue RS-485-2 line, A (+)
White RS-485-2 line, B (-)
Black External washer tank level monitoring (if
present)
Tab. 3