Victron energy BlueSolar SCC010005000, Manual

Page: 9 / 122

3. Installation Instructions
3.1 General Installation Notes

Read through the entire installation section before beginning installation.

Be very careful when working with batteries. Wear eye protection. Have fresh
water available to wash and clean any contact with battery acid.

Uses insulated tools and avoid placing metal objects near the batteries.

Explosive battery gasses may be present during charging. Be certain there is
sufficient ventilation.

Avoid direct sunlight and do not install in locations where water can enter the
controller.

Loose power connections and/or corroded wires may result in resistive
connections that melt wire insulation, burn surrounding materials, or even cause
fire. Ensure tight connections and use cable clamps to secure cables and prevent
them from swaying in mobile applications.

Use with Gel, Sealed or Flooded batteries only.

Battery connection may be wired to one battery or a bank of batteries. The
following instructions refer to a singular battery, but it is implied that the battery
connection can be made to either one battery or a group of batteries in a battery
bank.

Select the system cables according to 3A/mm
2
current density.
3.2 Mounting
NOTE: When mounting the controller, ensure free air through the controller heat
sink fins. There should be at least 6 inches (150 mm) of clearance above and
below the controller to allow for cooling. If mounted in an enclosure, ventilation
is highly recommended.