Victron energy BlueSolar SCC010005000, Manual

Page: 55 / 122

4. TROUBLESHOOTING
1. LED blinking, short circuit, check the PV and battery, and make
sure that they are in correct connection.
2. LED slowly flashing: fully charged.
3. LED ON: charging.
4. LED frequent flashing: battery connected, no charge current.
5. LED OFF: no battery or over voltage.
1. Check wires
2. Reduce Amps if needed
3. Reset controller
5. SETTING MODE
After pressing the on/off push button during 5 seconds, one of the
three leds starts flashing. Each LED expresses different
specifications, choose the LED by pushbutton according to the
following information, and then press the switch for 5 seconds until
the number you need is flashing, choose one number as you need,
leave it for save.
Battery type mode
Charging priority
Charging frequency
The 1st led is the battery type setting
Number shows Battery type
1 BAT 1
2 BAT 2
3 BAT 3
The 2nd led is for charging priority. Only set the percentage you
want for battery #1, the controller will automatically calculate the
rest for battery #2.
Number
shows Battery #1
charging Battery # 2
charging
0 0% 100%