Victaulic VE414MC, Operating And Maintenance Instruction Manual

Page: 37 / 64

TM-VE414/415MC_37 REV_D
TM-VE414/415MC / Operating and Maintenance Instructions Manual
4. Thread the upper support block’s bolt into
the upper shaft, as shown above. Tighten this
bolt securely.
NOTICE
• As the upper support block’s bolt is
tightened, it will draw the upper roll
assembly into proper alignment with the
lower roll.
5. Lubricate the upper roll, as shown. Refer to
the applicable “Recommended Lubricants” table
for the proper grease.
LOWER ROLL INSTALLATION FOR
4 – 16"/114.3 – 406.4 MM SIZES
NOTICE
• Clean the main shaft and the lower
roll’s bore of any dirt and/or scale
before installation. Make any repairs, as
necessary.
1. Carefully slide the applicable size lower roll
fully onto the main shaft with the marked side
facing forward, as shown above. Properly align
the roll with the Woodruff Key on the main shaft.
NOTICE
• To aid in removing the roll later, apply
a thin film of oil or grease (anti-seize
lubricant) to the main shaft before
installing the lower roll.