Victaulic VE414MC, Operating And Maintenance Instruction Manual

Page: 36 / 64

TM-VE414/415MC_36 REV_D
TM-VE414/415MC / Operating and Maintenance Instructions Manual
LOWER ROLL REMOVAL FOR
4 – 16”/114.3 – 406.4 MM SIZES
1. Loosen and remove the lower roll’s bolt
and retaining plate, as shown. Place these
components on a clean surface.
2.
Slide the lower roll off the main shaft, as
shown. Store the lower roll in the tool’s storage
compartment.
NOTICE
• Be careful not to lose the Woodruff key. It
should remain in the lower shaft. Inspect
the Woodruff key and replace if damaged.
Spare Woodruff keys are supplied with
instruction manual.
UPPER AND LOWER ROLL INSTALLATION
FOR 2 – 3
1/2 "/60.3 – 101.6 MM SIZES
1. Lightly lubricate the lower shaft with a thin
film of oil or grease before installing the lower
roll. Slide the 2 – 31/2
" /60.3 – 101.6 mm lower
roll onto the main shaft. Properly align the roll
with the Woodruff Key on the main shaft.
2. Place the 3/4-inch/19-mm flat washer onto
the 3/4 x 3 1/4 " /19 x 83 mm bolt. Install the bolt
and washer, as shown above. Tighten the bolt
securely with a wrench.
3.
Carefully slide the upper roll assembly
onto the upper shaft. Properly align the upper
support block with the recess in the slide, as
shown above.