16
VE272SFS Roll Grooving Tool
PIPE STABLIZER
ADJUSTMENT
(Applies only to tools equipped with the
optional pipe stabilizer)
The optional pipe stabilizer for the VE272SFS
is designed to prevent pipe sway for 8 –
12-inch NPS sizes in short and long lengths.
When the stabilizer is adjusted for a selected
pipe size and wall thickness, it does not re-
quire further adjustment unless pipe of a dif-
ferent size and wall thickness will be grooved.
Pipe of the same size and thickness may be
moved in and out of the tool without retracting
the stabilizer.
1.
Make sure the proper roll set is installed
on the tool for the pipe size and material to be
grooved. Rolls are marked with the pipe size,
part number, and they are color-coded ac-
cording to the pipe material. Refer to the "Tool
Rating and Roll Selection" section, starting on
page 39.
2.
Loosen the stabilizer locking handle. Us-
ing the hand wheel, retract the stabilizer roller
to clear the pipe when it is inserted onto the
lower roll.
3.
Insert a length of pipe that is the correct
size and schedule over the lower roll. Make
sure the pipe end contacts the lower-roll
backstop flange.
4.
Close the hand pump valve by turning
the knob
clockwise
.
5.
Using the hand pump, bring the upper
roll down into firm contact with the pipe.
6.
Make sure the guards are adjusted prop-
erly. Refer to the "Roll Guard Adjustment" sec-
tion on page 14.
WARNING
• Before making any tool adjustments, always turn
the switch on the power drive to the “OFF” position,
or disconnect the power cord from the electrical
source.
Accidental startup of the tool could result in serious
personal injury.
TM-VE272SFS 3776 Rev_B.fm Page 16 Friday, December 3, 2004 12:10 PM
Summary of Contents for VE272SFS
Page 2: ......
