32
VE272SFS Roll Grooving Tool
MAINTENANCE
This section provides information about keep-
ing tools in proper operating condition and
guidance for making repairs, when neces-
sary. Preventive maintenance during opera-
tion will pay for itself in repair and operating
savings.
Replacement parts must be ordered from
Victaulic Tool Company to ensure proper and
safe operation of the tool.
LUBRICATION
1.
After every 8 hours of operation, lubri-
cate the machine. Always lubricate the upper
roll bearings when rolls are changed.
2.
Grease the upper roll bearing at the
grease fitting with a No. 2EP lithium-base
grease, as shown above.
3.
Grease the main shaft bearings at the
grease fitting with a No. 2EP lithium-base
grease, as shown above.
4.
Lubricate the linkage mechanisms, the
arm pivot point, and the arm sliding surfaces
with a heavy-duty spray lubricant, or grease
may be applied by hand.
5.
For tools equipped with the optional
pipe stabilizer:
Lubricate the stabilizer wheel
with a No. 2EP lithium-base grease, as shown
above.
DANGER
• Before performing any mainte-
nance on the tool, turn the
switch on the power drive to the
“OFF” position, or disconnect
the power cord from the
electrical source.
Failure to follow these instructions could result in
death or serious personal injury.
TM-VE272SFS 3776 Rev_B.fm Page 32 Friday, December 3, 2004 12:10 PM
Summary of Contents for VE272SFS
Page 2: ......
