30
VE272SFS Roll Grooving Tool
LOWER ROLL INSTALLATION
for 2-inch and Larger Sizes
Lower Roll Installation
1.
Place the lower roll onto the arbor. Re-
position the roll guards, if necessary, to ease
assembly. Make sure the lower roll fits fully
onto the arbor.
NOTE:
The square drive flats
of the roll must be aligned with the square
drive flats of the arbor.
2.
Install the flat washer and thick nut onto
the threaded stud of the arbor in front of the
lower roll. Tighten the thick nut
clockwise
securely with a wrench.
3.
Install the thin jam nut onto the threaded
stud of the arbor. Using a wrench, tighten the
thin jam nut
clockwise
securely against the
thick nut.
4.
Close the hand pump valve by turning
the knob
clockwise
.
5.
Pump the hand pump several times until
the upper roll interlocks with the lower roll.
This will confirm proper roll installation.
NOTICE
• The arbor must be installed before attempting to
install the lower roll. Refer to the "Arbor Installa-
tion" section on page 29.
CAUTION
• Make sure the square drive flats of the roll are
aligned properly with the square drive flats of the
arbor.
• Make sure the thick nut is tightened securely onto
the threaded stud of the arbor.
Failure to follow these instructions can result in the
lower roll slipping on the arbor and causing damage to
the arbor.
TM-VE272SFS 3776 Rev_B.fm Page 30 Friday, December 3, 2004 12:10 PM
Summary of Contents for VE272SFS
Page 2: ......
