MVP3
SYSTEM BOARD
AWARD BIOS SETUP
4-24
Onboard FDC Controller
This should be enabled if your system has a floppy disk drive (FDD) installed on
the system board and you wish to use it. Even when so equipped, if you add a
higher performance controller, you will need to disable this feature.
The choice: Enabled, Disabled.
Onboard Serial Port 1/Port 2
This item allows you to determine access onboard serial port 1/port 2 controller
with which I/O address.
The choice: 3F8/IRQ4, 2E8/IRQ3, 3E8/IRQ4, 2F8/IRQ3, Disabled.
UART 2 Mode
This item allows you to determine which Infra Red (IR) function (CN10) of
onboard I/O chip.
The choice: Standard, ASKIR, HPSIR
Onboard Parallel Port
This item allows you to determine access onboard parallel port controller with
which I/O address.
The choice: 378/IRQ7, 278/IRQ5, 3BC/IRQ7, Disabled.
Onboard Parallel Mode
Select an operating mode for the onboard parallel (printer) port. Normal EPP
(Extended Parallel Port), ECP (Extended Capabilities Port) ECP+EPP PC AT
parallel port Bi-directional port Fast, buffered port Fast, buffered, bi-directional
port. Select Normal unless you are certain your hardware and software both
support EPP or ECP mode.
The choice: SPP, ECP/EPP, ECP, EPP/SPP.
