Display shuts off
Check to see if the “Turn display off when
idle” setting is enabled.
Won't shut off when I
press the power button
Press and hold the power button for 2
seconds.
CPA alarm doesn't
sound
1. Check the profile you have selected by
looking on the home page or choosing the
Alarm Profile item from the main menu on
the home page situation display.
2. Use setup to verify the CPA alarm
parameters for the current profile.
3. Check “CPA alarm” setting to make sure
it is enabled and set to a value greater than
the range of the target in question.
4. Ensure the “CPA alarm - Time” setting
isn't set too low.
5. Check the “CPA alarm – Target speed”
and “CPA alarm – Your speed” settings.
Alarms sounds for
every target
Use setup to verify the “Guard alarm
range” setting for the current profile. If this
setting is “ALL” then every target, no
matter how near or far, will trigger an
alarm.
Doesn't display
magnetic bearings to
targets
1. Check the setting of “Bearing to target
mode” in setup.
2. Ensure your GPS is sending magnetic
- 62 -
