Auto center/Crop
: this function takes current video frame and centers it by the detected fiber image inside program window, i.e. in case of
long (extension) tips or handshaking. Initially, the user will see a blank screen. Descriptions of sidebar options are provided below.
Resume:
Turns on or stops the video capture feed of the fiberscope.
Analysis On/Off:
a toggle switch function to turn on/off the Pass/Fail threshold concentric rings (yellow) defined by IEC 61300-3-35 standard.
Auto Freeze On/Off
: a toggle switch function when the image is fully focused, will automatically pause the video/frame capture.
Dots/Rects
: a toggle switch function that highlights areas of contamination/defects with boxes (rectangles) or dots (contour shape) based on
requirements and/or personal preference.
Dots function highlighting overlay
Rects function highlighting overlay
Shake
: a toggle switched, self-corrective function to minimize significant vibrations and unsteadiness generated from the user holding the
fiberscope, usually performed when scoping bulkhead/female connectors.Typically, users may not always need this function (image focusing
was good enough).
MPO mode On/Off
: a toggle switch function to enable multi-fiber connector endface analysis.
Single Fiber Workflow Setup
:
1. In the
Setup
tab , the user can define the following fields:
Auto Save functionality (Disabled, Save when auto freeze, Save upon
tap)
,
Job ID
,
Cable ID
,
Fiber ID
,
Test ID
, and
Increment
in the first page screen to define a unique identifier and saving results
structure,
<- Page 1/2 ->.
RXT1200_Platform_Manual_RevB01
Page 73 of 117
